发个可检查U盘是否能正常启动的微软官方工具

sztopms1

大家都在做量产，做完后有的却发现不能启动。 是否真的不能启动呢？ 给大家提供个出自微软的带debug功能的NTDETECT.COM，照它的方法试下，也许可以有作用。我自己实验的结果，还是比较好，但当有多个USB接口或带上了USB HUB时，可能会花很长的时间，在此期间屏幕完全一片黑，象死机了一样。

The BIOS may fail to properly enumerate USB bootable devices, which results in a blue screen
and failure of USB boot. When troubleshooting USB boot failure, use the NTDETECT.COM tool
and the following procedure to verify that the BIOS properly enumerates USB bootable
devices.
To verify USB bootable devices
Boot the device.
The tool displays the bootable devices identified by the BIOS.
If bootable devices are found, the following output appears:
Enumerating Interrupt 13 disks found on this system
DriveSelect-MaxCylinders-SectorsPerTrack-MaxHeads-NumberDrives
<NNN>-<NN>-<N>-<NN>-<NNN>
...
<NNN>-<NN>-<N>-<NN>-<NNN>
Enumeration done.  Press a key to continue...
where <NNN>-<NN>-<N>-<NN>-<NNN> represents the drive characteristics for each bootable
device.
If the BIOS fails to find any bootable devices, the tool displays failure reasons and
prompts the user to ignore and retry. Upon retry, the tool then enumerates any boot disks
found on the system with their drive characteristics.
Failure to find bootable devices may indicate a problem in any of the following areas:
BIOS
USB storage medium
motherboard
===================================
下载：

sds520

怎么用啊，呵呵

yangyongwang

下载来看看怎么样啊。。

apple666

是啊，介绍一下怎么用啊？

fujianabc

xp embedded中的一个用来检测的ntdetect.com，看见过。

df6688

怎么用呀,楼主请说说吧

sztopms1

5楼的是高手，拜读过你的不少文章，在此顺便致谢！

好几个都在问怎么用， 我一楼中中文下面的英文说得很清楚吧，微软的东西向来在帮助方向是做得很不错的。